Fri 08 Nov 2002 12:58:46 PM UTC, original submission:
I'm an Debian/GNU Linux user and an newbie in M68HC11
microcontroler.
I Bougth an control card (MRC11) from Mekatronix, and
pretend to use it
with linux.
I've downloaded the source files
* gcc-m68hc1x-20020922.tar.gz
<http://stephane.carrez.free.fr/gcc-m68hc1x-20020922.tar.gz>
* GNU Binutils 2.12.1
<http://ftp.gnu.org/pub/gnu/binutils/binutils-2.12.1.tar.bz2>
* GCC 3.0.4
<http://ftp.gnu.org/pub/gnu/gcc/gcc-3.0.4/gcc-3.0.4.tar.gz>
* GDB 5.2.1
<http://ftp.gnu.org/pub/gnu/gdb/gdb-5.2.1.tar.gz>
* Newlib 1.10.0
<ftp://sources.redhat.com/pub/newlib/newlib-1.10.0.tar.gz>
and aplied the patch files, as you tell in your seccio
INSTALL/BUILD
evrything is ok, except for the compilation of GDB (the
rest i haven't
any problems)
the steps i followed were:
# gzip -d gdb-5.2.1-m68hc1x-20020908.diffs.gz
# tar xvzf gdb-5.2.1.tar.gz
# mv gdb-5.2.1 gdb-5.2.1-m68hc1x
# cd gdb-5.2.1-m68hc1x
# patch -p1 < ../gdb-5.2.1-m68hc1x-20020908.diffs
after that i tried to create the make file with
# sh ./configure --target=m6811-elf
--program-prefix=m6811-elf-
after a litle bit while, i get the error message ...
-------------------------------------------
.
.
.
checking compiler warning flags... -Wimplicit
-Wreturn-type -Wcomment -Wtrigraphs -Wformat
-Wparentheses -Wpointer-arith -Wuninitialized
checking for cygwin... no
checking for tgetent in -lncurses... (cached) no
checking for tgetent in -lHcurses... no
checking for tgetent in -ltermlib... no
checking for tgetent in -ltermcap... (cached) no
checking for tgetent in -lcurses... (cached) no
checking for tgetent in -lterminfo... no
configure: error: Could not find a term library
Configure in /homestaff/bmarq/tmp/gdb-5.2.1-m68hc1x/gdb
failed, exiting.
-------------------------------------------
What's wrong ?
Are there any other GNU packges i Should have installed ?
Coul'd you help me ?
Best regards
Bruno F. Marques
(PORTUGAL)
|