# # This is just a raw copy of elfppc.sc and has not been otherwise modified # # Unusual variables checked by this code: # NOP - four byte opcode for no-op (defaults to 0) # DATA_ADDR - if end-of-text-plus-one-page isn't right for data start # OTHER_READONLY_SECTIONS - other than .text .init .rodata ... # (e.g., .PARISC.milli) # OTHER_READWRITE_SECTIONS - other than .data .bss .ctors .sdata ... # (e.g., .PARISC.global) # OTHER_SECTIONS - at the end # EXECUTABLE_SYMBOLS - symbols that must be defined for an # executable (e.g., _DYNAMIC_LINK) # TEXT_START_SYMBOLS - symbols that appear at the start of the # .text section. # DATA_START_SYMBOLS - symbols that appear at the start of the # .data section. # OTHER_BSS_SYMBOLS - symbols that appear at the start of the # .bss section besides __bss_start. # # When adding sections, do note that the names of some sections are used # when specifying the start address of the next. # test -z "$ENTRY" && ENTRY=_start test -z "${BIG_OUTPUT_FORMAT}" && BIG_OUTPUT_FORMAT=${OUTPUT_FORMAT} test -z "${LITTLE_OUTPUT_FORMAT}" && LITTLE_OUTPUT_FORMAT=${OUTPUT_FORMAT} test "$LD_FLAG" = "N" && DATA_ADDR=. SBSS2=".sbss2 ${RELOCATING-0} : { *(.sbss2) }" SDATA2=".sdata2 ${RELOCATING-0} : { *(.sdata2) }" INTERP=".interp ${RELOCATING-0} : { *(.interp) }" PLT=".plt ${RELOCATING-0} : { *(.plt) }" cat <