4 |
tend to be completed earlier than stuff towards the end. Additions? |
tend to be completed earlier than stuff towards the end. Additions? |
5 |
Opinions? Send 'em to me (d92-jwa@nada.kth.se). |
Opinions? Send 'em to me (d92-jwa@nada.kth.se). |
6 |
|
|
7 |
. Ditch the configure support for ripples -- 0.2 is a nice value. |
. Merge the GNOME2 port: |
8 |
|
x Merge src/Makefile.am into something that works with both GNOME1 |
9 |
|
and GNOME2. |
10 |
|
x Merge configure.in into something that works with both GNOME1 |
11 |
|
and GNOME2. |
12 |
|
x Verify that both the GNOME1 and GNOME2 port build out of the box. |
13 |
|
x Verify that both the GNOME1 and GNOME2 port install out of the |
14 |
|
box. |
15 |
|
|
16 |
. Clean up configure.in: |
. Create a screenshooting "port" of bubblemon. This port should run |
17 |
x Put all general system tests first, then general bubblemon tests, |
without displaying anything for like five seconds, then save a PNG of |
18 |
then platform (GNOME) specific tests clearly separated by comments. |
the current picture in the current directory. Its measurement |
19 |
|
implementations should return values appropriate for nice |
20 |
|
screenshots. This should not be installable using "make install", |
21 |
|
but it should be built iff libpng can be found. |
22 |
|
|
23 |
|
The point of this exercise (except for getting nice screenshots) |
24 |
|
would be to improve the portability of the configure stuff. Doing |
25 |
|
the port would probably resolve some of the configure.in cleanup |
26 |
|
stuff below. |
27 |
|
|
28 |
|
. Clean up configure.in: |
29 |
x Prefix all GNOME specific test results with GNOME_. |
x Prefix all GNOME specific test results with GNOME_. |
30 |
|
|
31 |
x Add a check for whether libgtop returns anything but zero for |
x Add a check for whether libgtop returns anything but zero for |